![](/images/new-backgrounds/1166446/1664467x1.webp)
INSTALLATION
Optionally Install Expansion Adapter
WARNING: Remove AC line cord from power source before installing expansion adaptor in
CAUTION: Wear a grounding device and observe electrostatic discharge precautions when installing Expansion Adapter in the
To install the expansion adapter in the
1.Locate expansion adapter plate at back of
Expansion Adapter Plate
2.Remove expansion adapter plate by using flatblade screwdriver to remove two (2) screws that secure expansion adapter plate to back of
NOTE: Retain screws for step 5. (Optionally discard expansion adapter plate.)
3.Carefully slide expansion adapter, component side up, into installation space revealed by removal of expansion adapter plate.
CAUTION: Do NOT force the connection. Failure to observe this caution could result in equipment damage and subsequent failure.
4.Press component on expansion adapter securely against internal mating
5.Secure expansion adapter by installing retained screws through expansion adapter into
YES
•Continue at step 7.
7.Is one (or more) of the
YES
•Continue at step 10
NO
•Continue at step 8.
8.Does one (or more) of the
YES
•Check fiber cables for proper connection.
•Verify that TX and RX cables on
•Ensure that terminal device(s) is/are powered.
•Contact Technical Support: (800)
NO
•Continue at step 9.
9.Is one (or more) of the 100BASE-FX STAT(us) LEDs dark?
YES
•The port is (or ports are) partitioned; investigate the attached terminal device(s).
•Contact Technical Support: (800)
NO
•Continue at step 10.
10.Is one (or more) of the 100BASE-FX ACT(ivity) LEDs illuminated?
YES
•The port is (or ports are) operational and receiving data.
NO
•Disconnect and reconnect the
•Restart the terminal device(s) to restart the initialization process.
•Contact Technical Support: (800)