Power the E-FX-HB-xx00
NOTE: When the hub is connected to an AC outlet supplying 100-240VAC at
50-60 Hz, the hub automatically powers ON
To power ON the E-FX-HB-xx00:
1. Locate power receptacle at back of E-FX-HB-xx00.
2. Plug unit end (female) of power cord into E-FX-HB-xx00 power
receptacle.
3. Plug outlet end (male) of power cord into correct voltage AC wall
socket.
4. At E-FX-HB-xx00 front, verify that P(o)W(e)RLED is illuminated.
Optionally Cascade Hubs

AT BACK

To cascade hubs by installing adapter cable(s) between stacked hubs:
1. Locate uplink adapter installed on E-FX-HB-xx00 9see page 4) and
adapter cable ACC-0201.
2. Install one end of adapter cable to UPPER connector on expansion
adapter on lowest hub in stack.
3. Install one end of adapter cable to LOWER connector on expansion
adapter on next hub in stack.
4. Continue steps 2-3 until installation is complete.

AT FRONT

To cascade hubs by installing fiber cables between hubs:
1. Locate or build 100BASE-FX compliant two-stranded fiber cable
with appropriate TX to RX connectors installed at both ends.
2. Connect male TX and RX cable connectors at one end of cable to
TX and RX female connectors, respectively, on front of one hub.
3. Connect male TX and RX cable connectors at other end of cable to
RX and TX connectors, respectively, on front of second hub.
STAT
10BASE-FL
12345678
PWR
COL ACT
BB
13
2457
68
STAT
10BASE-FL
12345678
PWR
COL ACT
BB
13
2457
68
TX

TX RX

RX
TX
TX
RX
RX