Milan Technology MIL-S16000T Rack-mounted Installation, 2. Attach mounting brackets with screws

Rack-mounted Installation

The MIL-S16000T comes with a rack-mounted kit and can be mounted in an EIA standard size, 19-inch rack. The Switch can be placed in a wiring closet with other equipment.

Perform the following steps to rack mount the switch:

A. Position one bracket to align with the holes on one side of the switch and secure it with the smaller bracket screws. Then attach the remaining bracket to the other side of the Switch.

Figure 3-2.Attach mounting brackets with screws

B.After attaching both mounting brackets, position the MIL-S16000T in the rack by lining up the holes in the brackets with the appropriate holes on the rack. Secure the Switch to the rack with a screwdriver and the rack-mounting screws.

Figure 3-3. Mount the MIL-S16000T in an EIA standard 19-inch Rack

Note: For proper ventilation, allow at least 4 inches (10 cm) of clearance on the front and 3.4 inches (8 cm) on the back of the Switch. This is especially important for enclosed rack installation.

7