SmartNode 4520 & 4110 Series User Manual | 3 • Hardware installation |
| |
Note Unit must not connect directly to telecom network voltage (TNV).
Installing the Ethernet cable
The SmartNode 4520 Series has automatic MDX (auto-cross-over) detection and configuration on the Ether- net ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable (see figure 20 on page 34). Ethernet devices (10Base-T or 100Base-T) are connected to the SmartNode’s Ethernet ports (see table 7 for port pin-out listing) via a cable terminated with RJ-45 plugs. Because the Smart- Node 4110 Series does not have the MDX feature, a cross-over cable is required when connecting SmartNode 4110 Series devices to a host (see figure 21 on page 35).
Table 7. Ethernet 10/100Base-T (RJ-45) port pin-outs (SmartNode 4110 Series)
Pin | Signal |
| |
1 | TX+ |
2 | TX- |
| |
3 | RX+ |
6 | RX- |
| |
Note Pins not listed are not used.
Figure 20. Connecting a SmartNode 4110 Series device to a hub
Installing the gateway router | 34 |
