Patton electronic 4110, 4520 Configure IP address, Power connection and default configuration

SmartNode 4520 & 4110 Series User Manual 4 • Getting started with the SmartNode

1. Configure IP address

The Interconnecting cables shall be acceptable for external use and shall be rated for the proper application with respect to volt-

CAUTION age, current, anticipated temperature, flammability, and mechanical serviceability.

Power connection and default configuration

First the SmartNode must be connected to the mains power supply with the power cable. Wait until the 'Run' LED stops blinking and lights constantly. Now the SmartNode is ready.

The factory default configuration for the Ethernet interface IP addresses and network masks are listed in table 8.

Table 8. Factory default IP address and network mask configuration

	IP Address	Network Mask
Interface Ethernet 0 (ETH0)	DHCP	DHCP
Interface Ethernet 1 (ETH1)	192.168.1.1	255.255.255.0

Both Ethernet interfaces are activated upon power-up.

If these addresses match with those of your network, go to section “2. Connect the SmartNode to the network” on page 42. Otherwise, refer to the following sections to change the addresses and network masks.

Connect with the serial interface

The Console port is wired as an EIA-561, RS-232 port. Use the included Model 16F-561 adapter and cable (see figure 25) between the SmartNode’s Console port and a PC or workstation’s RS-232 serial interface. Activate the terminal emulation program on the PC or workstation that supports the serial interface (e.g. HyperTerm).

Link

VoIP

Power Run

Link

100M			Activity
En	et	0

Link

			Activity	0/0
100M
En	et	1

					VoIP
					Integrated
				4524
SmartNode
				ToIP
		0/2		0/3
0/1
		Po	rts
	ice
Vo

Router

GatewayDevice

Access

Console

Figure 25. Connecting to the terminal

Terminal emulation program settings:

•9600 bp

•no parity

1. Configure IP address 40