Miller Electric 350P manual Set Up Push Motor Torque SUP

.A complete Parts List is available at www.MillerWelds.com

.Welding wire birdnesting at the welding power source drive rolls may occur if this value is set too high.

5-10. Set Up Push Motor Torque (SUP)

	5
3

1

1Setup Button

2Left Knob

3Left Display

4Right Knob

5Right Display

6Arc Control Button

Simultaneously press Setup and Arc Control buttons.

2 4

Rotate the left knob counterclockwise (CCW) to find the particular item, and rotate the right knob to change the setting.

The following items can be adjusted by rotating the left knob counterclockwise (CCW):

Set up Push Motor Torque (SUP) − This feature is only active when a push/pull gun is connected to the welding power source. The (SUP) setting will adjust the

6

Ref. 213 935-A

over-torque limit of the push motor inside the welding power source. The range is 0-250 and the default value is 130. Increasing this setting will increase the over-torque limit and speed up the remote wire feed speed motor.

.If Aluma-Pro push/pull gun has a

listed SUP value, set the power source to match the SUP value.

OM-1327 Page 40