FUNCTIONAL DESCRIPTION
| 1 |
| 5 |
| 4 |
2 | |
| 3 |
1. | Power button |
| |
| High: Red LED continuous |
| Medium: White LED continuous |
| Low: Blue LED continuous |
2. | Battery holder |
3. | Power cable port |
4. | Battery holder pocket |
5. | Power cable |
| ASSEMBLY |
WARNING Recharge only with the charger specified for the battery. For specific charging instructions, read the operator’s man- ual supplied with your charger and battery.
Inserting/Removing the Battery
To insert the battery, slide the pack into the body of the battery holder. Make sure it latches securely into place.
Insert the power cable (from inside the battery holder pocket) into the power cable port on the battery holder.
Place the battery holder into the pocket and zip closed.
To remove the battery, push in the release buttons and pull the battery pack away from the holder.
OPERATION
To turn on, press and hold the heated jacket power button (about 3 seconds). The heated jacket will begin to preheat (5 minutes) and then adjust to the medium setting.
Temperature setting can be adjusted at any time by pressing the heated jacket power button. Each press will cycle through the heated jacket’s tem- perature settings.
To turn off the heated jacket, press and hold the heated jacket power button until the LEDs turn off (about 3 seconds).
If the heated jacket turns off unexpectedly, check connections and charge the battery pack.
CARE
WARNING To reduce the risk of injury, always unplug the charger and remove the battery pack and battery holder from
the heated jacket before performing any maintenance. Never disassemble the heated jacket, battery pack or charger. Contact a MILWAUKEE service facility for ALL repairs.
If the heated jacket does not start or operate properly with a fully charged battery pack, clean the contacts on the battery pack. If the heated jacket still does not work properly, return the heated jacket, charger and battery pack, to a MILWAUKEE service facility for repairs.
WARNING Toreducetheriskofpersonal injury and damage, disconnect and re- move battery pack and battery holder from battery holder pocket before washing. Never immerse your battery holder, battery pack, or charger in liquid or allow a liquid to flow
inside them.
To clean the heated jacket:
1.Remove battery pack and battery holder.
2.Hand wash heated jacket in cold water. Do not use bleach. Do not wring. Do not machine wash even though machine may include a hand wash or equivalent cycle.
3.Hang dry. Do not machine dry. Do not iron.
ACCESSORIES
WARNING Always remove battery pack before changing or removing ac- cessories. Only use accessories specifically recommended for this tool. Others may be
hazardous.
For a complete listing of accessories refer to your MILWAUKEE Electric Tool catalog or go online to www.milwaukeetool.com. To obtain a catalog, contact your local distributor or service center.
3
