Installing/Removing Edge Guide (Fig. 9)
Installing Templet Guide
To install a templet guide, insert guide into
OPERATION
To install an edge guide, loosen the two rod screws. Insert the edge guide rods into the rod holes and tighten the rod screws.
Fig. 9 Rod screws
Rod holes
Installing/Removing Sub-base (Fig. 10)
Remove the
Fig. 10 | |
|
the center hole of router base and secure according to templet guide instructions.
NOTE: The
WARNING!
Unplug the tool before changing accessories or making adjust- ments.
Never make adjustments while the router is running.
Adjusting the Depth of Cut
The tool depth can be adjusted by using the depth adjustment knob or a 3/8" socket wrench.
When using the depth adjustment knob, fully open the locking lever and rotate knob to the desired depth of cut. One revolution of the depth adjustment knob is equal to 0.2". For fine adjustments less than 5/32", use the independent scale on the depth ad- justment knob.
For deeper cuts:
1.Align the "0" on the scale with the ar- row on the tool.
2.Rotate depth adjustment knob clock- wise to desired depth measurement.
For shallower cuts:
1.Align the desired depth measurement with the arrow on the tool.
2.Rotate depth adjustment knob coun- terclockwise to "0."
When using a socket wrench, place the router on a flat surface and fully open the locking lever. Insert a 3/8" socket wrench into the hole on the base and turn to de- sired depth (Fig. 11).
Fig. 11
Holding the Tool
For Body Grip Base (Fig. 12):
You can hold this tool using the body grip and handle or both handles. The body grip features an adjustable strap, which can be attached in two different positions for maximum control and comfort.
Fig. 12
Alternate strap positions
10 | 11 |
