ASSEMBLY
WARNING
Cat. No. 9081-20
This impact driver is intended for use with
WARNING
Recharge only with the charger specified for the battery pack. For specific charging instructions, read the operator's manual supplied with your charger and battery pack.
WARNING
Always lock trigger or remove battery pack before changing or removing accessories. Only use accessories specifically recom- mended for this tool. Others may be hazardous.
Removing Battery Pack from Tool
Push in the release buttons and remove the battery pack.
Inserting Battery Pack into Tool
Battery pack can be inserted into the tool in two ways.
1.For working in restricted spaces.
Insert the battery pack from the front by pressing in the release buttons and sliding battery pack into the body of the tool (Fig. 1). Insert the battery pack until clamp engages.
2.For optimum weight distribution and balance.
Insert the battery pack from the back by pressing in the release buttons and sliding the battery pack into the body of the tool (Fig. 2). Insert the battery pack until clamp engages.
Fig. 2
Use only sockets and other accessories specifically designed for use on impact wrenches and drivers. Other sockets and accessories might shatter or break causing injury.
Attaching and Removing Accessories Cat. No.
These impact wrenchs are intended only for use with sockets designed for im- pact wrenches that have a 3/8" (Cat. No.
1.To attach a socket or other accessory, align the accessory with the drive shank and push it firmly over the retaining ring.
2.To remove the accessory, pull the ac- cessory off the drive shank.
drill and driver bits.
1.To attach an accessory, pull the ring out and insert the accessory shank (Fig. 3 & 4). Release the ring (Fig. 5). It may be necessary to pull the bit out slightly to engage the holding mechanism.
2.To remove the accessory, pull out the ring and remove the accessory. Release the ring.
Fig. 3
Fig. 4
Fig. 1
Fig. 5
6 | 7 |
