13
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
2. Bracket C in the diagram below is installed on the face during the face
assembly (see instructions included with face). The captive screws D
on this bracket should be screwed into captive nuts E on the fireplace.
A phillips head screwdriver inserted through the vent holes in the face
can be used to complete this task. Align the face for plumb and level
and then tighten all four screws.
CAUTION: Any masonry that has been cleaned with an acid
wash must be properly neutralized before installing the fire-
place face. The acid wash will tarnish the face. Consult your
masonry installer.
Face Installation
A number of different faces are available for the Ravelle™ 42 gas fire-
place, however, all the faces are installed in a similar manner. A total of
four screws (two upper and two lower) attach the face to the fireplace.
To install a face:
1. Locate the two screws found in the hardware bag shipped with the face.
Position the face (with the lower door open) in front of the fireplace.
Install the two screws, A in the diagram below, through the holes in
the lower door hinge bracket and screw them into the captive nut on
tab B located on the fireplace. Do not fully tighten these screws yet.
ABCDEExpanded ViewExpanded View
Figure 16
Expanded View
Expanded View
C
DE
A
B