Cautions
Introduction to elegante
IMPORTANT SAFETY INSTRUCTIONS
When this symbol is shown there is a risk of electrical shock.
When this symbol is shown extreme caution should be observed.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.
Read these instructions.
Keep these instructions.
Heed all warnings.
Follow all instructions.
DO NOT use this apparatus near water.
Clean only with dry cloth.
DO NOT install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
Unplug this apparatus during lightning storms or when unused for long periods of time.
Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as
Install in accordance with the manufacturer’s instructions.
WARNING: If using spikes make sure that they do not pierce mains cable etc. under /above the carpet.
When making any connections, switch the amplifier off.
When you switch on your system or change sources, set the volume control at minimum and turn the level up gradually.
DO NOT use your amplifier at full volume.
Avoid extreme settings of tone controls or graphic equalisers. Ideally, they should be set ‘flat’ or, if possible, bypassed.
DO NOT place heavy objects on top of loudspeaker cabinets.
Ensure that all loudspeakers in the system are correctly wired and are in phase.
DO NOT connect your loudspeakers to the mains supply, except for subwoofers.
DO NOT attempt to dismantle the loudspeaker. There are no user serviceable parts inside and you will render the warranty void.
Site
Loudspeakers should not be placed directly facing other
Site unscreened speakers and subwoofers at least 0.5m away from TV sets, computers etc. Some manufacturers forbid the placing of objects on top of their TV sets. Check your TV handbook before installing the centre speaker directly on your TV set. Consult your TV dealer if you are in any doubt.
Use only attachments / accessories specified by the manufacturer.
DO NOT subject loudspeakers to excessive cold, heat, humidity or sunlight.
DO NOT block any ventilation openings.
DO NOT defeat the safety purpose of the polarized or
The apparatus must not be exposed to dripping or splashing and no objects filled with liquids, such as vases, should be placed on the apparatus.
Use only with a cart, stand, tripod, bracket or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart / apparatus combination to avoid injury from
CAUTION: e8as1, e8as2
The mains power switch for this appliance is located on the rear panel. To permit free access to this switch the apparatus must be located in an open area without any obstructions. The mains power plug must remain freely operable at all times.
CAUTION: Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate this device.
IMPORTANT NOTICE TO UK USERS. The subwoofer is supplied with a plug incorporating a fuse, the value of which is indicated on the pin face of the plug. Should the fuse or plug need to be replaced refer to the instructions on Page 8.
Thank you for purchasing Mission loudspeakers. The elegante series is the
latest in a long line of distinguished Mission loudspeakers. These technologically advanced loudspeakers will complement the finest electronics and decor. Mission engineers and craftsmen have designed and manufactured each speaker in the range to bring you the utmost enjoyment and listening pleasure over many years of use.
Please read these instructions carefully before installing your loudspeakers. A few
minutes studying this manual will ensure that the superb performance of elegante
will be fully achieved.
Fitting spikes
Use floor spikes on the floorstanding speakers, subwoofer and speaker stands, for an improvement in clarity of sound. The spikes can be used with pointed ends downward on carpets (fig 1), or domed end downwards on hard floors (fig 2). After levelling, make sure that the speakers are stable on their spikes, then tighten all lock nuts firmly.
Note that where more than four spikes are provided you may regard the extra spikes as an aid to stabilisation. Adjust the four main spikes first and then lower the extra spikes until they just touch the floor (fig 3).
Warranty conditions
The warranty card enclosed should be completed and returned to Mission or its Distributor within 8 days of purchase.
No Dealer or Distributor may vary the terms of this warranty which is personal to the original purchaser and is not transferable.
Please retain the sales receipt as proof of purchase.
Warranty claims must wherever possible be made through the Dealer from whom the equipment was purchased.
This warranty excludes:
Damage caused through neglect, accident, misuse, wear and tear, or through incorrect installation, adjustment or repair by unauthorised personnel.
Any unauthorised servicing will result in loss of warranty.
Liability for damage or loss occurring in transit to or from the purchaser.
Consequent damage, loss or injury, arising from or in conjunction with this equipment.
Equipment for attention under warranty should be considered return carriage paid. If equipment is found to comply with the published specification, Mission reserves the right to raise a charge.
The above conditions do not affect your statutory rights as a consumer.
fig 1 | fig 2 | fig 3 |
2 | 3 |
