∙Attach VCon IGC server T1 link to NSU, DSU or Embedded PRI card o Configure hardware for Line Termination through jumpers or DIP
switch – please refer to the Technician’s Handbook of the correct product (3300 or SX2000)
∙connect to server with a straight through cable
∙Program trunks
ofor example, please see Example of T1/D4 Programming on 3300 or SX2000
∙Test link to server by dialing <feature access code for individual trunk access> <trunk number><any 4 digit number>< # > e.g. <**2><6101><1000><#>
oYou should hear “Welcome to Remoteability”
∙Program ARS so a single four digit number accesses the IGC system
oProgram trunk group
oAdd trunks to trunk group
oCreate Digit Modification Assignment ** see following note
oCreate Route Assignment
oCreate ARS Digits Dialed Assignment
oPlease see Example of ARS Programming on 3300 or SX2000
**Note: The Dialogic card in the IGC server is expecting ANI on the T1D4 trunk, but the 3300 or SX2000 does not deliver ANI over T1D4. This will result in a 10 to 15 second delay in accessing the IGC after the trunk access number is dialed. To correct this, send an ANI digit string to the trunk through the Digit Modification Form. See below.
Digit Modification Assignment |
|
| ||
Digit | Number of | Digits to be | Final Tone | |
Modification | Digits to | Plan/Information | ||
Inserted | ||||
Number | Absorb | Marker | ||
| ||||
1 | 3 |
|
| |
2 | 0 |
|
| |
3 | 1 | <T01> |
| |
4 | 0 | **6135922122** |
| |
Example of T1/D4 (CAS) Programming on 3300 or SX2000
Class Of Service – changes from default values
Public Network Access via DPNSS | Yes |
7/4/2004 | Page 6 of 22 |
