Administrator Tools 

Administrator Tools 

- 33 - 

View a User Name 

1. Press   (

SUPERKEY

). 

2.  Press the third 

Personal

 key (counting upwards from the bottom on the 5312 IP Phone) 

or the 

Line 3

 key (counting upwards from the bottom right on the 5324 IP Phone). The 

user display name (top) and user name (bottom) appears. 

3. Press   (

SUPERKEY

)  to return to the default display. 

Device Parameters 

To view the software version and the MAC address: 

1. Press   (

SUPERKEY

), and then press 

>>

 until ADMIN TOOLS? appears on the 

display.  

2. Press 

OK

. DEVICE PARAMETERS? appears.  

3. Press 

OK

. SOFTWARE VERSION appears.  

4. Press 

Next

 to view either the software version or the MAC address. 

•

  To view the software version, press 

REVIEW

 (the current software version 

appears), then press 

OK

. SOFTWARE VERSION reappears. 

•

  To view the MAC address, press 

NEXT

 (MAC ADDRESS appears), then press 

REVIEW

. The current MAC address appears. Press 

OK

. MAC ADDRESS 

reappears. 

5.  Do one of the following: 

•

  To return to the DEVICE PARAMETERS? menu, press 

EXIT

. 

•

  To return to the default display, press 

 (

SUPERKEY

). 

Note:

  You can also view the MAC address using the 

Line 1

 key (see 

View the IP and MAC 

Addresses

 on page 34). You can also view the firmware version using the 

Line 2

 key 

(see 

View the Firmware Version

 on page 35). 

Protocols 

For information about supported communication and media protocols, access the 

Configuring 

Protocols 

topic of the Administrator’s 

Web Configuration Tool 

Online (see 

Accessing the Web 

Configuration Tool Online Help

 on page 7). 

Enable/Disable Protocols  

To enable/disable protocols using the Web Configuration Tool: 

•

  Access the tool’s 

Protocols

 page. 

Note

:  To access the Web Configuration Tool, HTTP must be enabled. If HTTP is disabled 

and you need to access the tool, enable HTTP through the Superkey Menu Interface 

(see procedure that follows below). 

To enable/disable protocols using the Superkey Menu Interface: 

Page 39
Image 39
Open full-size image