Mitsubishi Electronics 1786FD Getting Started

Getting Started

This monitor is equipped with an autosensing power supply for voltage ranges

100~240V AC, 50~60Hz.

To install the monitor :

1. Make sure that the system power is turned

off.

2. Please refer to the instructions below to

connect the signal cable through D-SUB .

3. Connect the power cord to the monitor

and attach it to power source.

4. Turn on the computer and the monitor.

Contents

Main 1786FD Colour Monitor Users Manual Page Table of Contents Page Copyright Fill in here!! Disclaimer Page Maintenance Page Introduction Unpacking the Package Features Power Management Getting Started Installing the Monitor Page Adjusting the Monitor Page Page Exit : Save Control functions available in main menu 1. Luminance 2. Geometry 3. Colour Adjustment 4. Recall geometry preset setting 5. Manual degaussing function ) 6. Miscellaneous Timing Setting Factory Preset Timings Troubleshooting and Useful Hints Need More Help? Specifications