Controller Set Up & Network Configuration 2408
f
& 2408
f
PROFIBUS Communications Handbook
4-2 2408
f
and 2404
f
PROFIBUS Communications Handbook
TO CONFIGURE THE CONTROLLER COMMUNICATIONS PARAMETERS

Select Configuration Level

Select Comms Configuration List

“HOME”
display
Press Page
button
repeatedly
until Access
List appears
or to enter password
(factory default = 1)
If incorrect
password
entered
or to enter
password
(
factor
y
default = 2
)
Note: Selecting
or
will allow direct entry
to these levels at this
point

Press to display: Identity of module

This should be a read-only parameter displaying

1st press

Press to display: Comms Resolution

Press or to select = Full, or = Integer is the recommended setting

2nd press

Press to display: Function

Press or to set = This selects PROFIBUS-DP protocol

3rd press
If the password has
been set to ‘0’ -
access is
permanently unlocked
& the lower readout
always shows PASS
Repeated pressing of “Page” button selects
configuration list headings in a continuous
loop
2 secs
At this point the
controller is in
configuration level
or to select
4th press