Indicators
This projector has two indicators, each of which shows the operation condition of the projector.
The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your dealer.
POWER indicator
STATUS indicator
Normal condition
POWER STATUS | CONDITION | NOTE | |
| Off |
| |
|
|
| |
Steady |
| Lamp | The power cannot be turned on by pressing |
red | Blinking | ||
|
| the POWER button. | |
| green |
| |
|
|
| |
| Blinking | Lamp | The power cannot be turned off by pressing |
|
| the POWER button. | |
| green |
| |
|
|
| |
Steady |
| The power is on. (Normal condition) |
|
green | Steady |
| |
|
|
| |
| green |
|
|
Abnormal condition
POWER | STATUS | CONDITION | POSSIBLE SOLUTION |
Steady |
| Abnormal temperature |
|
| • The ventilation grilles are clogged with dust or dirt. | • Clean the ventilation grilles. | |
green |
| ||
| • The room temperature is high. | • Relocate the projector to a cooler place. | |
or | Blinking orange | ||
|
|
| |
Steady |
|
|
|
red |
|
|
|
|
| The protection circuit is working or the lamp is in an | • Wait until the STATUS indicator goes out, |
Steady |
| abnormal condition. | then press the POWER button. |
Blinking green |
| • If the above solution is not effective, | |
red |
| ||
|
|
| replace the lamp. |
Steady |
| Lamp operation time warning. (Total lamp operation | Replace the lamp. |
Blinking green/red | time reached 3000 hours*1 while the power was on.) | Change with a new lamp if this problem | |
green |
|
| recurs. |
|
| Lamp operation time warning. (Total lamp operation | |
|
|
| |
| Blinking red | time reached 3000 hours*1 while the power was off.) |
|
Steady |
| Lamp operation time warning. (Total lamp operation |
|
red |
|
| |
| Steady red | time reached 4000 hours*1*2 while the power was off.) |
|
| Off | The lamp cover isn’t closed. | Close the cover correctly. |
|
|
| |
Blinking | Steady | Abnormal. | Contact your dealer. |
|
| ||
green/red |
|
| |
or |
|
| |
|
|
| |
| Blinking |
|
|
*1: Duration when LAMP MODE of the INSTALLATION menu is set to LOW. When it is set to STANDARD, this duration will be shorted.
*2: When LAMP MODE is set to STANDARD, this duration will be shorted up to 2000 hours.
