Mitsubishi Electronics HD-5000A manual Problem Possible Solution, HD- Owner’s Guide

Problem Possible Solution

• When a Device is selected from the Device Selection	• Make sure the selected device is turned on.
menu, the screen is blue (no signal source).	• From the Edit NetCommand® menu select Review then check the
	Review screen to see if inputs match the actual connections on the
	HDTV Receiver. If they do not match, either change the
	actual connections, or select Change on the EditNetCommand menu
	to change the HDTV Receiver’s Memory for the connection.
• The Device does not respond to key presses from the	• Remote has not been setup for NetCommand use. See the
remote.	HD- Owner’s Guide.
	• The incorrect manufacturer was selected during setup. Select
	Change on the Edit NetCommand menu and then select the device
	to display the manufacturer selection. Change if necessary.
	• The device is not supported.
	• The requested function is not supported by NetCommand.
	Verify the function supported.
	• The IR emitter is incorrectly placed. Make sure the IR
	emitter is facing the IR sensor in the device.
	• The IR emitter is not plugged into the IR emitter Output
	NetCommand.
	• The IR emitter is facing the HDTV Receiver IR Sensor,
	causing double signals. Be sure that the IR emitter cannot “see” the
	HDTV Receiver IR Sensor.
• The A/V Receiver is the selected audio source but	• Check to see if the A/V Receiver power is turned on. After the
there is no sound.	power is turned on, redisplay the Device Selection menu and press
	ENT(er) to allow NetCommand to correctly select the A/V Receiver
	input.
	• From the Edit NetCommand select Review. Check the Review screen
	to see if the A/V Receiver inputs for the selected configuration match
	the actual connections on the A/V Receiver. If they do not match,
	either change the actual connections, or select Change on the Edit
	NetCommand menu to change the HDTV Receiver memory for the
	connection.
• The Speaker icon or A/V Receiver icon is grayed	• Select Change from the Edit NetCommand menu, and then
out and not selectable.	select the device. Once the Connection screen is displayed,
	check if the audio checkbox is selected for the HDTV Receiver
	input and/or AVR input.
• Devices are grayed out in the Device Selection menu	• A recording is in progress requiring the use of Monitor Out.
or the PIP Selection menu.	Cancel the recording to select the device.
	• Digital devices (Ant-DTV and  devices) and devices with
	scanning rate of p or i cannot display in the PIP or
	POP.
• Cannot see the A/V Receiver menu.	• Normally, the A/V Receiver is not connected to any
	input of the HDTV Receiver. To check the A/V Receiver
	menu, temporarily plug into an unused input of the HDTV Receiver.
	Then after selecting Review from the Edit NetCommand menu,
	turn the input On to view the A/V Receiver menu.
• The REC button is not working, or, on the Transport	• The device does not support recording, such as a DVD player.
menu the record key is grayed out and not available.	• Recordings can not be initiated from the Transport menu when
	the device is an IEEE  device. To record to an IEEE 
	device, change the HDTV Receiver to the ANT-DTV or source
	device for the recording and press the REC key. The Record
	menu displays allowing setup of a recording.
• Excessive digital artifacts.	• The IEEE  cable is too long (maximum of  feet between
	devices.)
	•There may be a slow device in the middle of the IEEE 
	network. Move the slow devices to the end so that connections
	for faster devices do not pass through them.

19