Mitsubishi Electronics LT-2220, LT-3020 manual Cable Box, TV side panel left

Connecting an Antenna to a Cable Box and VCR, Connecting Audio/Video to the Cable Box or VCR

Note: The TV side panel and connections shown here are for reference only and may vary by model.

TV side panel (section detail)

3

Cable Box Rear Terminals

2	1	Incoming Cable
OUT	IN
VCR back panel
2	AUDIO OUT	AUDIO IN	VIDEO OUT
IN	L	L	(Y/C)
Antenna	1	2	1
			MONITOR
	R	R
3
OUT

Figure 5. Connecting the VCR with cable box.

TV side panel - left

Red

2
White	(Recommended if available)
	1	Attach only
		one cable type

						1
						Attach
					If your VCR has a video	only
						one
					channel or RF ON/OFF	cable
	VCR back panel				switch, set to OFF.	type
						1
			AUDIO OUT	AUDIO IN	VIDEO OUT
	IN	White	L	L	(Y/C)
2	Antenna		1	2	1
					MONITOR
		Red	R	R
	OUT

Figure 6. Connecting the VCR Audio/Video.

16

Cable Box

(Figure 5)

1.Connect the incoming cable to ANT on the TV side panel.

NOTE: For best performance, please see Composite Video with Audio or S-Video with Audio, below.

Composite Video with Audio or S- Video with Audio (Recommended)

(Figure 6)

1.Connect a video or an S-Video cable from VIDEO OUT on the VCR back panel to VIDEO or S-VIDEO, INPUT-1 or INPUT-2 on the TV side panel.

2.Connect a set of audio cables from AUDIO OUT on the VCR back panel to AUDIO INPUT-1 or INPUT-2 on the TV side panel.

•The red cable connects to the R (right) channel

•The white cable connects to the L (left) channel

If your VCR is mono (non-stereo), connect only the white (left) cable.

You may connect to the S-VIDEO or VIDEO terminal but not to both.