Mitsubishi Electronics LT-3020, LT-2220 manual Connecting MonitorLink/PC Image and Audio Connection

Connecting MonitorLink™/PC Image and Audio Connection

Note: The TV side panel and connections shown here are for reference only and may vary by model.

MonitorLink

TV side panel - right

(Figure 14)

1.Connect a MonitorLink/DVI cable from the TV side panel to the Mitsubishi HD Receiver/Controller back panel.

2.Connect the MonitorLink Control/RS-232 cable from the TV side panel to the Mitsubishi HD Receiver/ Controller back panel.

3.Connect the L (left) and R (right) audio cables from the HDTV receiver to AUDIO LEFT and AUDIO RIGHT on the MonitorLink section of the TV side panel.

NOTE: The 29-pin MonitorLink/DVI and 9-pin RS-232 cables can be found at your local electronics store. Please refer to www.mitsubishi-tv.com for more information on RS-232C control.

CAUTION: To assure continued FCC compliance, the user must use a shielded video interface cable with bonded ferrite cores at each end, when using the MonitorLink/DVI input.

TVside panels

White	3
Red
ferrite core
1
2
-403XF5K

2

panel
backMacintosh¨orPCto	1

Figure 15. Connecting Computer

PC Image and Audio Connection

(Figure 15)

•Your Mitsubishi display supports VGA, SVGA, XGA, and WXGA PC resolutions only. (60Hz only)

1.Connect a Mini D-sub 15-pin (RGB) cable from the TV side panel to PC or Macintosh® back panel.

2.Connect a PC Audio Cable (or 1/8” stereo

mini jack cable) from the TV side panel to PC or Macintosh back panel.

MitsubishiHD-5000 receiver/controller back panel

S
V			3
L		White
A
A
R
AC IN		MonitorLinkTM Red
MonitorLink TM	DIGITAL AUD
CONTROL/RS-232	OUTPUT	/DVI

	403XF-5K
2	1

ferrite core

Figure 14. Connecting MonitorLink

NOTE: The Mini D-sub 15-pin (RGB) and 1/8” (3.5mm) stereo mini jack cables can be found at your local electronics store.

NOTE: Connecting your computer to this TV will allow you to display your computer’s images. Since this monitor is widescreen (16:9 aspect ratio), the display configuration will vary depending on which video card or driver(s) you use. You may also need to use a Macintosh adapter when connecting to some Macintosh computers.

21