Mitsubishi Electronics MDT421S < Remote control numbering function >

To use a computer to control the monitors

When using a computer to control the monitors, you must prepare an application software program for control by yourself.

1. Connect the RS-232C IN connector of the Master monitor shown above and the RS-232C connector of the computer using

an RS-232C cable.

Or, using a CAT5 cable, connect the RS-232C connector of the computer to the CAT5 IN connector of the Master monitor via

the CAT5 Tx BOX.

2. Assign a monitor ID to each multi-connected MDT421S using MONITOR ID. (See step 2 on page 33.)

3. Set AUTO BRIGHTNESS on the OSD screen (PICTURE) as follows.

REMOTE

SECONDARY

Master monitor

Slave monitors

AUTO BRIGHTNESS CONTROL

4. For the speciﬁ cations of the communication commands, contact your dealer.

< Remote control numbering function >

By connecting multiple MDT421S monitors using RS-232C cables, you can control any one monitor or all the monitors by one

remote controller.

1. Assign arbitrary ID number to each of multi-connected MDT421S monitors using MONITOR ID.

ID numbers 1 to 26 are selectable.

It is recommended to assign sequential ID numbers from 1 and up.

2. The remote control mode of the ﬁ rst MDT421S monitor is set to PRIMARY and those of the other monitors are set to

SECONDARY.

3. When you direct the remote controller at the remote control signal sensor of the PRIMARY monitor and press the DISPLAY

button on the remote controller, the ID selection OSD appears at the upper left of the screen.

ID:1

ID No. :2

Select the ID number of the monitor you want to control using the +/- button

on the remote controller.

The ID of the monitor you want to control is displayed at the upper left of its screen.

By selecting ALL, you can control all the multi-connected monitors.

ID number of the currently viewed monitor

4. Direct the remote controller at the remote control signal sensor of the PRIMARY monitor.

OSD appears on the monitor having the ID number you selected.

NOTE:

When the ID selection OSD is being displayed on the PRIMARY monitor, press the DISPLAY button on the remote controller

again to cancel the ID selection OSD and then control the monitor you selected.

NOTE:

If you set the remote control mode wrongly and remote control operation becomes unavailable, press any button on the control

panel of the monitor to display the OSD screen and change the remote control mode using ADVANCED OPTION. By pressing

and holding down the DISPLAY button on the remote control for 5 seconds or longer, the remote control mode is initialized to

NORMAL.

Downloaded From TV-Manual.com Manuals