• OPERATING INSTRUCTIONS •
NAME OF EACH PART
Indoor unit
Air cleaning filter |
|
Front panel | |
Air filter |
|
(Catechin air filter) | Air inlet |
| Emergency |
| operation |
| switch Page 4 |
Remote controller
Signal transmitting section Distance of signal : About 6 m
Beep(s) is (are) heard
from the indoor unit when
the signal is received.
Operation display 
section
Air outlet |
|
Vertical vane |
|
Horizontal vane | Display section |
| Operation indicator |
| lamp |
| Remote control |
| receiving section |
Outdoor unit
Air inlet (back and side)
Piping
Drainage hose
Air outlet
ON/OFF
(operate/stop) 
button
FAN speed control button
Page 5
Operation select button
Page 4
ECONO
COOL button Page 6
VANE control button
Page 5
LONG button
Page 6
Temperature buttons
Page 4
Page 5
TIME set buttons Pages 3, 6
Increase time
Decrease time
CLOCK button Page 3
RESET button Page 3
Lid
Slide down to open
Remote controller holder
Drain outlet
Appearance of the outdoor unit may differ from some models.
• Install the remote control- ler holder to a place where the signal can be received by the indoor unit.
Use the remote controller provided with the unit only.
Do not use other remote controllers.
PREPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
4. Press RESET
1. Remove the front lid
Setting current time
1. Press CLOCK
ES |
|
ET | C |
| LO |
| CK |
2. Insert AAA alkaline batteries
3. Install the front lid
• Make sure the polarity of the batteries is correct. | |
• | Do not use manganese batteries. The remote controller could malfunction. |
• | Do not use rechargeable batteries. |
3. Press CLOCK again
RESET
2.
Press the TIME buttons to set the time
Each press increases/decreases the time by 1 minute (10 minutes when pressed longer)
• Replace all batteries with new ones of the same type. | |
• | Batteries can be used for approximately 1 year. However, batteries with |
| expired shelf lives last shorter. |
• | Press RESET gently using a thin stick. |
If the RESET button is not pressed, the remote controller may not operate correctly.
• Press CLOCK gently using a thin stick.
