4.2 Redial
You may redial the
4. 3 CHARGE/IN USE indicator
The base unit’s CHARGE/IN USE indicator is lit when the handset is charging in the base unit, or when the handset’s RINGER switch is set to the ON position.
The base unit’s CHARGE/IN USE indicator flashes during a phone call, or when the PAGE/FIND but- ton is pressed.
4.4 Muting the microphone
To mute the microphone and temporarily stop the transmission of your voice, slide the mute switch on the headset’s cord.
4.5 Clearing static interference: CHANNEL button
The CH/CHANNEL button can be pressed to get rid of static interference. Press and release to proceed to a clear channel.
4.6 Temporary Tone Dialing
Note: This feature is only useful if you use pulse dialing service.
Talk
Mute
Temporary Tone Dialing lets pulse (rotary) service phone users temporarily
access
To use Temporary Tone Dialing, complete the following:
1.Remove the handset from the base unit (if not out).
2.Press the TALK/CALL BACK button on the handset.
3.Dial the telephone number.
4.When you call is answered by an automated service, press the *TONE/CANCEL button on the handset to temporarily change from pulse to tone dialing.
5.Follow the automated instructions as required.
6.Press the TALK/CALL BACK button to hang up. The handset automatically returns to pulse (rotary) dialing mode.
4.7 Canceling instruction: *TONE/CANCEL button
Press the *TONE/CANCEL button to cancel any command you initiated.
4.8 Locating misplaced handset
To locate a misplaced cordless phone, press the PAGE/FIND button on the base unit. The cordless phone will beep continuously for 2 minutes, or until any other button on the cordless phone is pressed. You may also press PAGE/FIND to cancel the cordless phone’s beeping.
Note: The RINGER switch does not have to be ON for this feature to work.
4.9 Ringer Switch
The handset RINGER switch must be ON for the cordless phone to ring during incoming calls.
9
GN7170_userguide.ind 9
13/08/04 9:56:03
