Outdoor LEV (SLEV, LEV1) Coil Removal Procedure (configuration)
As shown in the figure, the outdoor LEV is made in such a way that the coils and the body can be separated.
<Removing the Coils>
Fasten the body tightly at the bottom (Part A in the figure) so that
the body will not move, then pull out the coils toward the top. If
they catch on the stopper and are difficult to take out, turn the
coils left and right until the stoppers are free from the stopper
indentations, then pull the coils out.
If you take out the coils only without gripping the body, undue
force will be applied to the piping and the pipe may be bent over,
so be sure to fasten the body in such a way that it will not move.
<Installing the Coils>
Fasten the body tightly at the bottom (Part A in the figure) so that
the body will not move, then insert the coils from the top, inserting
the coils’ stopper securely in one of the indentations on the body.
(There are four indentations for the stopper on the body around
its circumference, and it doesn’t matter which indentation is
used. However, be careful not to apply undue force to the lead
wires or twist them around inside the body.) If the coils are in-
serted without gripping the body, it may exert undue force on the
piping, causing it to become bent, so be sure to hold the body
firmly so that it won’t move when installing the coils.
Part A
Coils Stopper
Lead Wires
Body
Indentation for
Stopper
(12 places
around the
circumference)
Part A
-
48
-