Mitsubishi Electronics XL5980LU user manual Using the remote control, Battery installation

Using the remote control

Battery installation

Use two AA size batteries.

1.Remove the back cover of the remote control by pushing the battery compartment door in the direction of the arrow.

2.Load the batteries making sure that they are positioned correctly (+ to +, and - to -).

• Load the batteries from - spring side, and make sure to set them tightly.

3.Replace the back cover.

1 2 3

Important:

•Use of a battery of wrong type may cause explosion.

•Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.

•Dispose of used batteries according to your local regulations.

•Batteries may explode if misused.

•Do not recharge, disassemble, or dispose of in fire.

•Be sure to handle batteries according to the instructions.

•Load batteries with the positive (+) and negative (-) sides correctly oriented as indicated on the remote control.

•Keep batteries out of reach of children and pets.

•Remove the batteries, if the remote control is not used for a long time.

•Do not combine a new battery with an old one.

•If the solution of batteries comes in contact with your skin or clothes, rinse with water. If the solution comes in contact with your eyes, rinse them with water and then consult your doctor.

Operation area (for wireless control system)

The range for operation is about 10 m (about 32 feet) when the remote control points to the projector. The dis- tance to the screen back to the projector must be less than 7 m (about 23 feet). Depending on the type of the screen, the distance will be different.

20˚

15˚

20˚

15˚

30˚

30˚

20˚ 20˚

Important:

Avoid the direct sunlight or fluorescent light to the remote control sensor. Also keep the distance of more than 2 m (6.5 feet) between the remote control sensor and fluorescent lamp on the remote control may not work correctly.

Using the wired remote control

Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired remote control is useful for operating in a distance or outside of the operating area.

REMOTE IN
								USB
• When REMOTE OUT terminal on this projector is connected to						RS-232C	RS-232C/MOUSE
	REMOTE REMOTE		INPUT 1	R/PR	G/Y	B/PB	H/HV	V
	IN	OUT
the REMOTE OUT terminal on the other projector, the two	MAIN		INPUT 2		AUDIO			VIDEO
projectors can be controlled together by using the remote					IN		S-VIDEO	2
						Y		VIDEO
control. (Up to two projectors can be controlled.)		AC IN			AUDIO	C		1
					OUT
								L
								AUDIO
								R
REMOTE OUT
REMOTE IN

•When the remote control is connected with remote control cable, it does not work as a wireless remote control.

•For connection, use the pin-pin cable of ø3.5 stereo type, which is commercially available. However, some cable may not work correctly.

•When using the wired remote control, the laser beam may be darker. It is normal.

EN – 8