MK Sound CS-29, CS-35, CS-22 Speaker Placement, WIRING FOR DIPOLE OPERATION CS-150ONLY

COLUMN SURROUND SPEAKER

TRIPOLE® OR DIPOLE OPERATION (CS-150 ONLY)

To operate in the Tripole® mode, the jumper between the terminals labeled "3" and "4" must be in place. To operate the speaker in the Dipole mode, the jumper between the terminals labeled "3" and "4" must be removed. Do not throw away or lose this jumper. See Figures 3 and 4.

VERY IMPORTANT: The sensitivity of the speaker is slightly higher in the Tripole® position. For critical listening, when switching from one mode to another, you should re-calibrate the level of the surround channels.

FIGURE 3

WIRING FOR DIPOLE OPERATION

(CS-150 ONLY)

(Only one channel is shown)

Disconnect the Jumper between terminals 3 and 4

		TRIPOLE
Connect your	1	SURROUND SPEAKER
	INPUT
amplifier to
terminals	4 ohms
1 and 2	2
		DO NOT CONNECT YOUR
FOR THX		AMPLIFIER TO TWO RED
(DIPOLE)		TERMINALS.
		For remote control operation,
OPERATION:
remove jumper		see your owner's manual.
between	3
terminals
3 and 4
FOR TRIPOLE
OPERATION:
install jumper	4	MILLER & KREISEL
between
		SOUND CORPORATION
terminals
		9351 Deering Avenue, Chatsworth, CA 91311
3 and 4
		818/701-7010 fax: 818/701-0369 www.mksound.com

-	+	-	+
LEFT SURROUND		RIGHT SURROUND

FIGURE 4

WIRING FOR TRIPOLE® OPERATION (CS-150 ONLY)

(Only one channel is shown)

Connect the Jumper between terminals 3 and 4 (Factory default)

1

Connect your	INPUT
amplifier to
terminals	4 ohms
1 and 2		2
FOR THX
(DIPOLE)
OPERATION:
remove jumper
between	3
terminals
3 and 4
FOR TRIPOLE
OPERATION:
install jumper	4
between
terminals
3 and 4

TRIPOLE

SURROUND SPEAKER

DO NOT CONNECT YOUR

AMPLIFIER TO TWO RED

TERMINALS.

For remote control operation, see your owner's manual.

MILLER & KREISEL

SOUND CORPORATION

9351 Deering Avenue, Chatsworth, CA 91311 818/701-7010 fax: 818/701-0369 www.mksound.com

-	+	-	+
LEFT SURROUND		RIGHT SURROUND

5. SPEAKER PLACEMENT

The Column Surround speaker takes a unique new approach to producing high-quality sound from the surround channels in the listening room. Conventional surround speakers must be mounted on the side walls, back wall, or ceiling of the room in order to produce good sound. But the Column Surround speaker can be located virtually anywhere in the room to produce a very effective coverage of sound.

5