poweredsubwoofers | page 8 |
FIGURE 3 - TO AN AMP OR RECEIVER USING SPEAKER WIRES
AMPLIFIER OR RECEIVER
+ | + |
BASS LEVEL
REFERENCE | |
- 3 dB | +3 dB |
- 6 dB | +6 dB |
| +9 dB |
AMPLIFIER | LEFT | + |
FROM | RIGHT | + |
|
|
| LOW PASS FILTER | |
LEFT/MONO | RIGHT | PHASE | VARIABLE | (Hz) |
|
| + | 75 | |
| INPUT |
|
| 100 |
|
| - | 60 |
|
|
| BYPASS |
| |
|
|
| 50 | 125 |
! | CAUTION |
RISK OF ELECTRIC SHOCK | |
DO NOT OPEN |
AVIS: RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
NOTE: See Fig. 4 for additional options
ATTENTION: | CAUTION: |
|
DEBRANCHER AVANT DE | DISCONNECT SUPPLY CORD |
|
REMPLACER LE FUSIBLE. | BEFORE CHANGING FUSE. |
|
UTILIZER UN FUSIBLE | REPLACE FUSE ONLY |
|
DE RECHANGE DE MEME TYPE. | WITH SAME TYPE. |
|
| 120 VAC 50/60 Hz | T 2 AMP |
MILLER & KREISEL SOUND CORPORATION | ||
10391 Jefferson Blvd, Culver City, CA 90232 |
|
IMPORTANT NOTE FOR DOLBY PRO LOGIC SURROUND SYSTEMS:
(NOT DOLBY DIGITAL 5.1)
When the Subwoofer is connected to the Left and Right amplifier outputs, the Center channel WIDE/ NORMAL switch MUST be set to the NORMAL mode. If the switch is set to the WIDE mode, the bass content of the Center channel will not be fed to the Subwoofer, and a significant amount of bass in the program material will not be reproduced.
SATELLITE SPEAKER WIRING OPTIONS
If you use speaker wires to connect the subwoofer, you have two options for the Satellite speakers.
1.Connect both the Satellite speakers and the subwoofer direct to your amp or receiver, with one set of wires running to the Satellites and another set to the Subwoofer. See Figure 4, below.
FIGURE 4 - SATELLITE SPEAKER WIRING (OPTIONAL)
AMPLIFIER OR RECEIVER
+ | LEFT |
+ | RIGHT |
BASS LEVEL
REFERENCE | |
- 3 dB | +3 dB |
- 6 dB | +6 dB |
| +9 dB |
AMPLIFIER | LEFT | + |
FROM | RIGHT | + |
|
|
| LOW PASS FILTER | |
LEFT/MONO | RIGHT | PHASE | VARIABLE | (Hz) |
|
| + | 75 | |
|
|
|
| |
| INPUT |
|
| 100 |
|
| - | 60 |
|
|
| BYPASS |
| |
|
|
| 50 | 125 |
! | CAUTION |
RISK OF ELECTRIC SHOCK | |
DO NOT OPEN |
AVIS: RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
+
SATELLITE SPEAKERS
+
ATTENTION: | CAUTION: |
|
DEBRANCHER AVANT DE | DISCONNECT SUPPLY CORD |
|
REMPLACER LE FUSIBLE. | BEFORE CHANGING FUSE. |
|
UTILIZER UN FUSIBLE | REPLACE FUSE ONLY |
|
DE RECHANGE DE MEME TYPE. | WITH SAME TYPE. |
|
| 120 VAC 50/60 Hz | T 2 AMP |
MILLER & KREISEL SOUND CORPORATION | ||
10391 Jefferson Blvd, Culver City, CA 90232 |
|
If your receiver or amp has two sets of speaker outputs, you may connect the Satellite speakers to one set of outputs and the Subwoofer to the other set.
