MK Sound MX-SERIES, V-125THX USE of Spiked Feet with MX Subwoofers, Troubleshooting

THX subwoofers page 14

9. USE OF SPIKED FEET WITH "MX" SUBWOOFERS

If your M&K THX subwoofer is an "MX" push-pull dual driver subwoofer, we have enclosed a hardware kit consisting of four black metal spikes, threaded at one end and tapering to a sharp point at the other. Depending on their orientation, they can be used either as carpet spikes or rubber feet.

To avoid damage to the floor, do not use the spiked end on hardwood or tile floors.

By mounting these spikes into the threaded inserts mounted in the bottom of the subwoofer, you can elevate the subwoofer, and on carpet couple it more tightly to the floor.

The threaded inserts are found in the four corners of the cabinet's bottom. The inserts are 1/4 - 20, that is, 1/4 inch in diameter and 20 threads per inch. This is compatible with the majority of alternative spikes, "cones," "tip-toes," etc. offered by other manufacturers.

To properly secure the feet to the cabinet, you must use the provided washer and jamb nut on the threaded portion of the foot. The washer goes first, with the nut over it, holding the washer securely in place. This prevents damage to the spike and insert in case something pushes the cabinet laterally.

10. TROUBLESHOOTING

Your subwoofer amplifier circuit provides high reliability, and, if necessary, easy modular parts replacement. This guide will help solve or diagnose most problems that may occur. Remember, if a fuse blows, you must replace it with the correct value to avoid fire hazards and to maintain the warranty.

1. If your subwoofer has no output:

a.Make sure that the subwoofer is plugged into an AC outlet.

b.If the "BASS LEVEL" switch is set to "VARIABLE", make sure that the "BASS LEVEL" control is set above the "MIN" position. Rotate it clockwise if it is set to the "MIN" position. Make sure that the SUBWOOFER OUTPUT level control on your processor or amp is set above the "MIN" position.

c.If the "BASS LEVEL" control is set to "THX", make sure that any SUBWOOFER OFF/ON switch (found on the controller front or rear panel or remote control) is set to ON. Make sure that the SUBWOOFER OUTPUT level control on your THX controller is set above the "MIN" position.

d.Check the red LED on the subwoofer's back panel. If the LED is not lit, check the AC fuse next to the LED. Unplug the subwoofer before changing the fuse. See instructions on Page 15. If the element inside the fuse is broken, replace the fuse. If the fuse blows again, contact your dealer or M&K.

e.If the red LED is still lit, set the "BASS LEVEL" switch to the "VARIABLE" position. Turn the "BASS LEVEL" control to "MIN". Plug a standard RCA cable into the "LEFT/MONO" "FROM PREAMP" jacks. Lightly touch the plug at the free end of the cable. Then turn the "BASS LEVEL" control clockwise. If you hear a buzz or hum from the subwoofer when you touch the cable, the subwoofer is working. Look elsewhere in your system for the problem. If you hear no output, contact your dealer or M&K for service.

f.Make sure your cables are OK. Double check all connections and replace any defective cables.