INSTALLATION & SET UP
Installing Batteries
Your MobiCam AV can be powered by either using the supplied AC power adaptors or batteries.
Using Batteries:
a)Remove the battery door (12, 26) at the bottom/ back of each unit by loosening the
b)Both units use 1.5 volt AA size batteries. Always use batteries of the same brand and age (alkaline recommended). Insert 4 AA batteries into the camera and 6 AA batteries into the monitor.
c)Replace the covers by aligning the tabs with the tab holes and tightening the
CAUTION: Remove batteries immediately once they run out of power and dispose of them properly. Do not use batteries while using the AC adaptor for extended periods of time as this might cause battery leakage.
Using AC Adaptors:
a)Insert the AC adaptor into the DC Jack (9, 23) of either unit (The AC adaptors are the same for both the Camera and Monitor).
b)Plug the AC adaptor plug into a standard AC power outlet.
CAMERA OPERTATION & INSTALLATION
Power ON/OFF
Use the Power ON/OFF sliding switch to turn ON/OFF the unit (21).
Channel Selection
Press the Channel Selection Switch (17) on the Camera to choose which channel you want the unit to transmit on. The channel indicator LED (16) will illuminate which channel the Camera is set to (A or B).
Voice Activation
To Activate: Select the VOX setting on the Function Activation Switch (18)on the left side of the Camera unit. When the sound level within the area surrounding the unit reaches a preset level, the Camera will begin transmitting the image and sound to the Monitor.
NOTE: The LCD on the Monitor unit will automatically switch to standby mode if no signal is received from the Camera
To Deactivate: Select the CAMERA setting on the Function Activa- tion Switch of your camera.
Automatic Infra-Red Night Vision
The
7 | 8 |