MT149A
®
INSTALLATION INSTRUCTIONS
THESE INSTRUCTIONS MUST BELEFT WITH HOMEOWNER
KITCHEN WALL MOUNT FAUCETS
Models 8713, 8714
Measurements
8" CENTERS
ADJUST FROM 7-1/2" TO 8-1/2"
1/2" VERTICAL ADJUSTMENT
9" SPOUT (MODEL 7400, 8713)
12" SPOUT (MODEL 8714)
7" NOMINAL
OPEN POSITION
2-1/16"
Complies with ASME A112.18.1M and CSA B125
Always turn water off before disassembling the valve. Open valve handle to
CAUTION: alleviate water pressure to insure that complete water shut-off has been accomplished.
Before turning water on during either rough-in or trim-out, make sure that cartridge retainer clip is in place. The cartridge and retainer clip were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible that through the handling of the valve by any number of persons the retainer clip may not be properly installed. This should be carefully checked at time of rough-in and trim-out. If the retainer clip is not properly installed, water pressure could force the cartridge out of the casting. Personal injury or water damage to the premises could result.
