Reassembly
1.With cartridge stem UP, insert cartridge with ears aligned front to back (illustra- tion 4).
2.Push the cartridge down by the ears (Illustration 5) until the top of the ears are flush with the top of the body.
3.Turn notched flat of cartridge stem toward front of sink. (Note: for cross piping installations, see instructions on back page).
4.Replace the clip all the way (Illustration 6).
5.Replace spout. Push down until it nearly touches the faucet escutcheon.
6.Screw on retainer pivot nut. DO NOT CROSS THREAD. Tighten firmly.
7.Press cartridge stem down. Holding handle UP, (Illustration 7), hook handle ring (inside the handle body) into groove on the retainer pivot nut.
8.Swing handle back and forth until it drops down into place.
9.Replace handle screw. Tighten securely. Push handle cap down until it snaps into place.
EARS
Illustration 4
Illustration 5
CLIP
EAR
Illustration 6
HOLD
UP
Illustration 7
To Eliminate
Reversed Rough-In Where Hot and Cold Positions Are Reversed:
Remove handle cap, handle screw and handle assembly (see “Disassembly” instructions). Turn valve stem around
so that the notched flat is turned one half turn or 180˚.
Maintenance
Your new faucet will give good service for an extended period of time. Should foreign materials in the system affect its operation, routine repairs can be easily made. If your faucet drips from the spout end or leaks up through the handle, follow “Disassembly“ instructions and replace with the cartridge listed in the Replacement Parts List, on page 4. If your faucet leaks from either the top or bottom of the spout hub, use the Spout Seal Kit (listed in the Replacement Parts List) and replace.
