TECHNICAL SPECIFICATIONS
TURBOFAN 150 (Gas)
Specification Information
Model No.: | SGL150CXN |
Power: 3P + N + E, 400 - 415 volt, 50 Hz, 2.42kW
Gas requirements : 200 MJ/hr
Natural gas supply 2.0 kpa to burner gas valve (3/4” BSP connection)
LP gas supply 3.0 kpa to burner gas valve (3/4” BSP connection)
Connections: | 1/2” BSP water supply connection and ½” copper drain located at rear of oven | |
Dimensions: | Width:1820mm |
|
| Depth: 1720mm | (includes canopy) |
| Height: 2700mm | (includes canopy) |
Weight: | 850kg |
|
Installation Information
Client to provide the following connections:
| Oven requires direct wiring from switchboard. Note: element wattage may vary by 5% | |
| Water connection ½” BSP. | Drainage connection ½”copper drain pipe |
Note: | Oven supply does not include canopies and flues as required by relevant authorities. | |
| Bends or offsets in the flue restrict gas velocity and must be allowed for when designing | |
| the flue height and diameter which will be dependent on the building and local | |
| conditions. |
|
| Chimney flue to be taken to atmosphere 127mm diam. | |
| Oven exhaust flue 200mm dia (canopy models), 100mm dia (non canopy models) | |
Clearance: | 50mm clearance is required at back and sides of unit | |
| Minimum 2900mm ceiling height |
|
Floor: | A concrete or tile surface is preferred. | |
| The floor area is to be flat to within 3mm over whole floor area. | |
Access: | Oven is supplied partially assembled to be fully erected on site. | |
| Largest piece if partially assembled | 2130mm H x 1820mm W x 1220mm D |
| Largest piece if unassembled | 2130mm H x 1820mm W x 660mm D |
In line with policy to continually develop and improve its products, Moffat reserves the right to change specifications and design without notice.
Australia | New Zealand | |
Moffat Pty Limited | ||
Moffat Limited | ||
Free Call 1800 023 953 | ||
Free Call 0800 663 328 | ||
email: vsales@moffat.com.au | ||
email: sales@moffat.co.nz | ||
www.moffat.com.au | ||
www.moffat.co.nz SGL150CXN 0403V1 |