MoistAir HD14070 owner manual Water Fill continued

QUARKSP6647 HD14070:SP6647 .qxd 12/10/2009 3:39 PM Page 7

Water Fill (continued)

Each water bottle is designed with a “Side-Fill Cap” that is easily removable. Remove the “Side- Fill Cap” on the side of the water bottle by twisting counterclockwise.

Place the opening of the water bottle under a water faucet (the bottle should fit under a four-inch clearance faucet). Fill with recommended mixture of cold water and Bacteriostat (if necessary) only. Solid debris could make the valve leak.

Install the “Side-Fill Cap” by twisting clockwise.

Hand tighten only.

Check for possible leaks by performing the following:

1. Grasp bottle handle and hold the bottle upright over a sink.

2. Press up on the valve cap plunger for about one second to let out a little water.

3. Release the plunger.

4. Listen for air bubbles Look for leaks around the “Side-Fill Cap”.

5. If you hear air bubbles or see leaks, retighten the “Side-Fill Cap” and repeat Steps 1-4.

Wipe off excess water from the bottle.

Position the water bottle back into the unit by grasping the water bottle handle and lower it into the cabinet until the bottle sits on pads at bottom of cabinet. The “Side-Fill Cap” must be facing the rear of the cabinet. When positioned properly, the plunger will open and water will flow into the cabinet. The water level will automatically remain at approximately 1/2” until the bottles are empty.

Allow the filter to saturate for 30 minutes before operation.

7