2 Using the 9491 Boot Kit
Putting the Boot on the Printer To put the boot on the printer:
1. Industrial Version Only. Remove the cable from the side of the
printer. Save the cable’s screws for when you want to use the
printer without the boot.
2. Unscrew the screw assemblies at the top of the printer (either
shoulder strap is optional), and take them off. Save them for when
you want to use the printer without the boot.
3. Pull on the boot and fit it around the printer.
4. With Shoulder Strap Only. For both sides of the printer, put
together the knob assembly and screw it into the threaded insert.
Do not over-tighten the assembly.
Using the Old Strap Using the New Strap
White
Spacer