C o n n e c t i n g t h e C o m m u n i c a t i o n s C a b l e s

The printer uses either 9-pin serial communications or USB communications. For best results, use only Monarch® cables.

1. Open the hinged cable door on the side of the printer by loosening the two screws with a Phillips screwdriver.

2. Plug the DB9 connector into the DB9 serial port, or plug the type A or mini-B USB connector into the appropriate USB port.

3. Place the cable in one of the cable cavities.

4. Close the cable door and tighten the screws.

USB cable

I n s t a l l i n g t h e M o u n t

The vehicle mount is 9.5 inches (240 mm) wide and 7.5 inches (187.5 mm) long.

Following is a list of the mounting hardware included with the vehicle mount:

♦four M6 60x2¼-inch screws (3/16-inch hex)

♦four lock washers

♦one mounting plate

♦two aluminum strap buttons

♦one M3 allen wrench

70.0 mm

50.80 mm

Overhead view of mount showing location and spacing of mounting holes.

2