Assembly
To attach the plinth, invert the speaker as shown (see Fig. 3), resting the top on a
By hand, screw the spikes into the location holes until they just touch the plinth.
Carefully turn the loudspeaker the right way up and position it so that the spikes rest on the floor discs supplied in the toolbox (if used). Place the supplied spirit level on top of the speaker. Next, use the allen key supplied to adjust each spike in turn until the speaker is level. This is accomplished by inserting the longer shaft of the allen key into the spike hole on the top face of the plinth and locating it in the spike recess. Slowly rotate the key clockwise and the spike height will increase. Only once the spikes have been adjusted by the necessary amount should the thumbwheels be rotated (anticlockwise) to lock the spikes in position. If you do not wish to use the plinth see Fig. 4.
Warning: If using spikes make sure that they do not pierce any cables that may be under the carpet. When handling your loudspeakers with spikes use extreme caution.
Fig. 3. Showing additional plinth and spike fixing
Fig. 4. Showing spike fixing
7
© Monitor Audio Ltd 2001