7
Place canopy on downrod.
10
Insert downrod into yoke on top of the Fan Body. Align the hole in the Downrod with the hole in the Yoke.
13
Tighten the 2 set screws on the Yoke once the downrod is in place.
16
Make sure the studs protruding from the bottom of the Mounting bracket are installed with threads all the way through the bracket.
8
Place canopy ring on downrod.
11
Insert the Pin through the Yoke and Downrod until the point appears on the other side.
14
Hang assembled fan from the mounting bracket installed to ceiling in previous step. Make sure the fan is hanging straight. Rotate fan until the tab on the Mounting bracket engages the slot on the Downrod Ball. This must be done to prevent the fan body from rotating when the blades are in motion.
|
|
|
|
|
| 17 |
| House | Fan |
|
| |||
|
|
| ||
| Black | Blue | ||
| Black | |||
| White | |||
| White | |||
| Ground | Green | ||
Connect black and blue wire from fan to Black or (Hot) wire from house. Connect White wire from Fan to White (Neutral) wire from house. Connect Ground leads from mounting bracket and downrod to Ground lead from house. Refer to Safety Tips section of manual.
9
Thread leadwires and safety cable through the downrod.
12
Install the keeper to pin.
15Safety cable installation
Safety Cable
Lag Screw
safety cable
washer
3” 
lag lock screw washer
Fan and light kit combinations over 35 lbs, in both flush and downrod mode the safety cable must be installed into the house struc- ture beams using the 3” lag screws,washers, and lock washers. provided. Make sure that when the safety cable is fully extended the lead wires are longer than the cable and no stress is placed on the lead wires.
18
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded con- ductor and the
