19
Tread leadwires and safety cable through the downrod.
22
Install 6x15 Watt candelabra bulbs included.
25
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
28
Place floating brackets onto blades aligning holes in blade with the floating bracket.
20
Place downrod into the yoke, align the holes in the yoke with the holes in the downrod and install cross pin. Install keeper pin into cross pin.
23
| Hang assembled fan from the mounting bracket |
| ||||||||||||
|
| |||||||||||||
| installed to ceiling in previous step. Make sure |
| ||||||||||||
| the fan is hanging straight. Rotate fan until the |
| ||||||||||||
| tab on the Mounting bracket engages the slot |
| ||||||||||||
| on the Downrod Ball. This must be done to |
| ||||||||||||
| prevent the fan body from rotating when the |
| ||||||||||||
| blades are in motion. |
|
|
|
|
|
|
|
|
| ||||
| 26 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Black |
| House |
|
|
| Fan |
| Black |
|
| ||
|
|
|
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
| |||||
|
|
| White |
|
|
|
|
|
|
| White |
|
| |
|
|
| Green |
|
|
|
|
| Green(downrod) |
| ||||
|
|
|
|
|
|
|
|
| Green(Bracket) |
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Make wire connections as per above diagram. Connect the white wire from the fan to the White or Neutral wire from the power source. Connect the black wire from the fan to the Black or hot wire from the power source. Connect all Green / Yellow wires from the fan, Downrod and mounting bracket to the Ground wire from the house.
29
Place blade arms onto the other side of the blade and aligning holes. Insert screws with fabric washers though the holes and tighten securely.
21
Tighten set screws to hold downrod securely in the yoke. Drop cover over yoke.
24
Canadian mounting only
Safety Cable
Lag Screw
For Canadian installation in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws provided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the leadwires.
27
30
Remove motor screws from fan motor and save.
