7
Tighten both yoke set screws to further secure downrod.
10
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
8
Carefully lift fan assembly onto mounting bracket. Rotate fan so that the notch on the ball engages the ridge in the mounting bracket. This will allow
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| House |
|
| Fan |
|
|
|
11 |
|
|
|
| Black | ||||||
|
| Black |
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
| Blue |
|
|
|
| White |
|
|
|
|
| White |
|
| |
|
| Green |
|
|
|
|
|
|
|
| |
|
|
|
|
| Green(downrod) |
| |||||
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
| Green(Bracket) |
|
For pullchain controls, follow diagram above. Make sure that all exposed wiring is secured inside wire nuts. Note: Wires from house may vary in color and may not include ground wire. After wiring is conplete, gently push wires into junction box with wire nuts pointing upward. Refer to point 3 of safety tips.
| Safety cable installation |
9 | |
|
|
Safety Cable
Lag Screw
For Canadian installation and for USA fan and light kit combinations over 35 lbs, in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws provided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the leadwires.
12
Fan Switch
Light Switch
Wall
Control
For control of fan and optional light from wall location, follow diagram above. NOTE: A profes- sional electrician is recommended for this type of installation.
13
Raise the canopy up and align the two holes in the canopy with the two holes in the hanger bracket. Secure with two screws provided.
14
Place blade onto blade holder.
15
Install 3 screws and washers per blade and tighten securely. Repeat for all 5 blades
16
17
Check the motor for plastic shipping stabilizer tabs, and remove them if they are present. Attach blade assembly to motor using the motor screws and washers provided. Tighten screws securely.
After attaching blade; reinstall the switch hous- ing using the three screws previously removed.