19
Place canopy over fan body aligning holes.
20
Replace the 3 screws removed and tighten securely. Check motor for shipping stabilizers and remove if present.
21
Hands free hook
Remove the all thread studs from the lower part of the mounting bracket. Hang fan from mounting bracket by the hands free hook into a closed hole on the edge of the Canopy. Note: For Canadian mounting refer to Step #8.
22
23
House
Black
White
Ground
Fan
Blue
Black
White
Green
24
Take 4 screws from hardware pack and insert 2 one on each side of bracket to match the L slot screw holes in canopy. Keep 2 screws for later use.
25
Lift fan to mounting bracket, aligning the “L” shape holes on the canopy with the screws on the mounting bracket. Turn the fan clock- wise to lock in position.
28
Remove nut and save for next step.
Connect black and blue wire from fan to Black or (Hot) wire from house. Connect White wire from Fan to White (Neutral) wire from house. Connect Ground leads from mounting bracket and downrod to Ground lead from house. Refer to Safety Tips section of manual.
26
Place blade holders onto blades aligning holes in blade holder with holes in blade. Make sure that the side of the blade you select is facing downward. Install 3 screws and fiber washers to back side of blade as shown. Tighten screws securely. Repeat this process 4 more times until all blades are assem- bled.
29
Remove switch cap housing from fan. Remove the plug from center of fit- ter. Install switch cap housing to light kit by turning clockwise to tighten.
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded con- ductor and the
27
Install blades to motor using the 10 motor screws provided. Tighten screws securely.
30