7
Install downrod into yoke.
10
Tighten 2 downrod set screws.
13Canadian mounting only
Safety Cable
Lag Screw
For Canadian installation in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws provided. Make sure that when the safety cable is fully extended the leadwires are longer than the cable and no stress is placed on the leadwires.
16
Lift Canopy to ceiling aligning the key hole slots with the screws on the bottom of the Mounting bracket. Rotate the canopy Counter Clockwise to lock in place. Tighten the screws to secure the Canopy. See inset for Keyhole shape
8
Align hole in downrod with hole in yoke and install cross pin.
11
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communcate properly. If you have other fans you can set to control from one transmitter by setting both receivers the same as the transmitter. If you have more than one fan with remote. You can set the dip switches to different positiosns to have seperate control.
14
Make wire connections as per above diagram. Connect the white wire from the fan to the White or Neutral wire from the power source. Connect the black wire from the fan to the Black or hot wire from the power source. Connect all Green / Yellow wires from the fan, Downrod and mounting bracket to the Grounding wire from the house.After wire nuts are installed push connections carefully into outlet box with wire nuts pointing upward.
17
Attach blade brackets to blades using the blade bracket screws and washers provided.
9
install cotter pin into cross pin.
12
Raise fan with downrod assembled to the ceil- ing bracket and hang fan assembly. Be sure to rotate the downrod ball so that the notch in the bracket engages the slot in the ball.
15
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
18
Check the motor for plastic shipping stabilizer tabs, and remove them if they are present. The screws, washers and motor pads are pre- installed to the blade holders. Attach blade assembly to motor and tighten screws securely.
