7
Place downrod into fan yoke.
10
Tighten the 2 set screws on the yoke once the downrod is in place.
8
Align the hole in the Downrod with the hole in the Yoke. Insert the Pin through the Yoke and Downrod until the point appears on the other side.
11
Hang assembled fan from the mounting bracket installed to ceiling in previous step. Make sure the fan is hanging straight. Rotate fan until the tab on the Mounting bracket engages the slot on the Downrod Ball. This must be done to prevent the fan body from rotating when the blades are in motion.
9
Install the keeper to pin.
12Safety cable installation
Safety Cable
Lag Screw
safety cable
washer
3” 
lag lock screw washer
Fan and light kit combinations over 35 lbs, in both flush and downrod mode the safety cable must be installed into the house struc- ture beams using the 3” lag screws,washers, and lock washers. provided. Make sure that when the safety cable is fully extended the lead wires are longer than the cable and no stress is placed on the lead wires.
13
14
House Fan
15
Make sure the studs protruding from the bottom of the Mounting bracket are installed with threads all the way through the bracket.
16
Lift canopy and install knurled nuts as shown. Tighten the knurled nuts securely. The canopy should adjust for any irregu- larity in the ceiling or Outlet box.
Black |
|
|
|
| Blue | |
|
|
| ||||
|
|
|
| Black | ||
|
|
|
| |||
White |
|
|
|
|
| |
|
|
|
| |||
|
|
|
|
| White | |
|
|
|
|
| ||
|
|
|
|
| ||
Ground |
|
|
|
| Green | |
Connect black and blue wire from fan to Black or (Hot) wire from house. Connect White wire from Fan to White (Neutral) wire from house. Connect Ground leads from mounting bracket and downrod to Ground lead from house. Refer to Safety Tips section of manual.
17
Place decorative blade medallion on blade opposite blade arm. Make sure the “up” side of blade arm is installed upper.
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wirenut. After making the wire connections, the wires should be spread apart with the grounded con- ductor and the
18
Attach blade arms using screws and washers in hardware pack. Tighten screws securely.
