19
Place upper housing over downrod.
22
Hang assembled fan from the mounting brack- et installed to ceiling in previous step. Make sure the fan is hanging straight. Rotate fan until the tab on the Mounting bracket engages the slot on the Downrod Ball. This must be done to prevent the fan body from rotating when the blades are in motion.
25Safety cable installation
Safety Cable
Lag Screw
safety cable
washer
3” 
lag lock screw washer
Fan and light kit combinations over 70 lbs, in both flush and downrod mode the safety cable must be installed into the house struc- ture beams using the 3” lag screws,washers, and lock washers. provided. Make sure that when the safety cable is fully extended the lead wires are longer than the cable and no stress is placed on the lead wires.
28
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wire nut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
20
Place canopy over downrod.
23
26
Install remote receiver by sliding into opening in the Mounting bracket. Make sure that the dip switches on the Transmitter and the Receiver are set to the same position.
29
Lift Canopy to ceiling aligning the key hole slots with the screws on the bottom of the Mounting bracket. Rotate the canopy Counter Clockwise to lock in place. Tighten the screws to secure the Canopy. See inset for Keyhole shape
21
Install ball on downrod, replace cross pin and tighen screw securely.
24
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
Set dip switches on the Remote Transmitter and Remote Receiver to the same settings. This must be done so the units will communcate properly. If you have other fans you can set to control from one transmitter by setting both receivers the same as the transmitter. If you have more than one fan with remote. You can set the dip switches to different positiosns to have seperate control.
| 27 |
|
|
|
|
|
| Fan |
|
| House |
| |||
|
|
|
|
|
|
|
|
|
| ||||||
| fuses |
|
|
|
| white |
| white | |||||||
|
|
|
|
|
|
|
|
|
| black |
|
|
| ||
|
|
|
|
|
|
|
|
|
| orange |
| black | |||
|
|
|
|
|
|
|
|
|
|
| blue | Green | |||
|
|
|
|
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
| |||
Make wiring connections as indicated above. White from fan to white from remote marked N. Orange from fan to Orange from remote marked Light/up. Blue from fan to blue from remote marked down light. Black from fan to Black from remote marked L. White from house to white from remote marked AC N . Black from house to Black from remote marked AC L. Connect all green ground wires to Ground wire from House.
30
Attach blades to blade arms with screws and washers supplied. Repeat for all 5 blades.
