31
Install blade and blade holder assembly to fan motor using the pre- installed screws,washers and motor pads. Repeat this process 4 more times until all blades are installed to the fan.
34
Place over the 2 screws and twist in direction of arrow to hold in place. Replace screw removed and tighen all 3 screws securely.
37
Loosen 3 screws with key hole slots.
40
Install 3 x 40 watt candelabra bulbs.
32 At this point you need to decide if you are using the light kit or not.
If not using light kit go to step 33. If using light kit go to step 36.
35
Install center plug by turning in direction of arrow.
38
Plug white wire from fan to white wire from light kit. Then plug black wire from fan to black wire from light kit.
41
Install ornate lower cover and glass onto light kit.
33
Loosen 2 screws and remove 1 screw.
36
Loosen 2 screws with key slots and remove 1 screw without key slot. Place upper cover light kit over 2 screws and twist in direction of arrow to hold in place. Replace screw removed and tighten all 3 securely.
39
Place light kit over 3 screws and twist in direction of arrow to hold in place. Then tighten all 3 screws securely.
42
Install center plug by turning in direction of arrow till tight.
