19Safety cable installation
Safety Cable
Lag Screw
safety cable
washer
3” 
lag lock screw washer
Fan and light kit combinations over 70 lbs, in both flush and downrod mode the safety cable must be installed into the house structure beams using the 3” lag screws,washers, and lock washers. provided. Make sure that when the safety cable is fully extended the lead wires are longer than the cable and no stress is placed on the lead wires.
| 22 |
|
|
|
|
|
| Fan |
|
| House |
|
| |||
|
|
|
|
|
|
|
|
|
|
| ||||||
| fuses |
|
|
|
| white |
| white |
| |||||||
|
|
|
|
|
|
|
|
|
| black |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| orange |
| black |
| |||
|
|
|
|
|
|
|
|
|
|
| blue | Green |
| |||
|
|
|
|
|
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
Make wiring connections as indicated above. White from fan to white from remote marked N. Orange from fan to Orange from remote marked Light/up. Blue from fan to blue from remote marked down light. Black from fan to Black from remote marked L. White from house to white from remote marked AC N . Black from house to Black from remote marked AC L. Connect all green ground wires to Ground wire from House.
25
Loosen 2 screws with key hole slots and remove 1 screw.
28
Install assembled ornate glass cover and glass to fan body by twisting in direction of arrow to hold in place.
20
23
Make wire connections to power source using wire nuts provided. Make sure that no filiments are outside of the wire nut. After making the wire connections, the wires should be spread apart with the grounded conductor and the
26
Install 4 x 25 watt candelabra bulbs.
29
Tighten all 3 screws securely loos- ened in step 25.
21
Install remote receiver by sliding into opening in the Mounting bracket. Make sure that the dip switches on the Transmitter and the Receiver are set to the same position.
24
Lift Canopy to ceiling aligning the key hole slots with the screws on the bottom of the Mounting bracket. Rotate the canopy Counter Clockwise to lock in place. Tighten the screws to secure the Canopy. See inset for Keyhole shape
27
Place glass into ornate glass cover.
30
Attach blades to blade arms with screws and washers supplied. Repeat for all 5 blades.
