Morphy Richards manual Replacing The Brita Memo, Switching On, 43541 Rev1 29/4/08 1627 Page

43541 Rev1 29/4/08 16:27 Page 1

•Change display G: Every week, one bar will disappear to show the remaining cartridge life. After four weeks, all four bars will disappear. This, and a flashing arrow, indicate that the cartridge should now be changed. Insert a new cartridge according to the instructions, and reactivate the Memo as described above.

G

REPLACING THE BRITA MEMO

BRITA Memo - the electronic cartridge exchange reminder has a life of approximately 5 years. At the end of the Memo’s life, please remember that it is an electronic device and to dispose of the Memo according to all applicable provisions and regulations. To remove the exhausted Memo, place a screwdriver in the notch next to the Memo and push it out. Please note that Memo should not be removed for any other reason than to dispose of it.

More information on the use of BRITA filter cartridges and the BRITA Memo can be found in the BRITA information guide supplied with the kettle.

Telephone our replacement parts helpline for your new BRITA Memo.

SWITCHING ON

You do not need to wait until the water has filtered through before boiling.Your Morphy Richards filter kettle will boil and filter at the same time, giving you boiled BRITA filtered water quickly.

•Boil only as much water as you need, as this saves electricity.

1Place the filter kettle on the base unit, ensuring the kettle locates on to the 360° connector.

•The 360° connector allows the kettle to be located at any position - ideal for left and right handed users and convenient positioning on a worktop.

2Plug in and switch on at the wall socket.

3Switch the kettle on. The kettle will illuminate internally.

4When the water boils, the filter kettle will switch off automatically.

•If you are using the kettle for the first time, discard the water and repeat once more.

•To re-boil, switch to ON again. If the kettle has just switched off, wait a minute or so before switching it back on again.

•If you do not put in enough water, or switch on the filter kettle when it is empty, the safety cut-out will switch off the power automatically. If this happens, refill and wait a few minutes for the element to cool, then use as normal.

5Lift the filter kettle from the base unit by the handle, ensuring you hold the kettle level.

WARNING: Unless the cartridge holder is fitted correctly, the filter kettle may not operate correctly and the lid may not close and lock securely.

WHEN TO

CHANGE

YOUR BRITA

MAXTRA

CARTRIDGE

This depends on water quality and the improvement required. We recommend that you change your cartridge after 4 weeks.

The electronic reminder on your Morphy Richards water filter kettle will remind you when to change your cartridge.

BRITA filter cartridges conform to the highest quality standards. Raw materials and final products are subject to stringent internal and external controls. BRITA filter cartridges are steam sterilised. An independent institute certifies the food grade quality of BRITA water filters and cartridges.

Great taste, less waste:

The BRITA MAXTRA cartridge is 100% recyclable. Please contact BRITA customer care team for advice on recycling schemes on

0844 742 4800, or visit www.brita.co.uk/recycle H.

H

HINTS AND TIPS

Cleaning and maintenance

WARNING: Always disconnect the plug from the mains and allow the appliance to cool before cleaning.

Wipe the outside with a damp cloth.

IMPORTANT: Do not use abrasive cleaners on the outside of the appliance, as they may scratch the surface.

5 UK Helpline 0844 871 0954 Replacement Parts 0844 873 0720 Ireland Helpline 1800 409 119