70191rev2 17/1/06 1:31 PM Page 4
Operation
Suction hose
Lining up the locking tabs on the hose to location slots on the vacuum. Push the hose end Ë into the suction hose inlet fl on the vacuum cleaner.Turn the rotating hose
clockwise until it clicks.Make sure it is securely in place. The appropriate cleaning tool can be attached directly to the other end of the suction hose.
Switching on
Plug the appliance into the mains supply. Ensure that the variable power control „ isset to minimum by turning the dial anti- clockwise as far as it will go. Push the on/off switch ‰ to start the suction motor. Turn the variable power dial clockwise to the desired power. Push the switch again to turn off the motor
Controlling suction power
The suction power can be varied to suit the surface being cleaned, by using the variable power control „.
The suction power can also be adjusted using the fingertip control on the handle of the suction hose Ë.
Closed: full suction
Open: reduced suction
Closed
Open
4
