Morphy Richards Bagless Cylinder Vacuum Cleaner manual DUST CANISTER Emptying, Allergy Sufferers

71067 Rev2 29/10/07 15:24 Page 6

C

D

E

OPEN

ô

DUST CANISTER

Emptying

To obtain the best results from your cleaner empty the dust canister regularly, otherwise the airflow and cleaning power will be reduced.

1Every time the dust canister is emptied, turn the yellow dial (a minimum of 5 revolutions) prior to pressing the dust canister release button (this will agitate the fine dust between the filter pleats and restore the air flow)

2Remove the dust canister from the product by pressing the dust canister release button Ü. Lift up the lid and remove the canister from the product, pulling the dust canister away from the product. C

3Holding the dust canister over a dustbin press the dust release button as shown D, the bottom of the dust container will drop down to release the dirt.

4Close the bottom of the dust canister by pressing the base upwards until it clicks into place.

5Refit the dust canister back into the product. Make certain the dust canister feet are located in place.

6Close the lid securely.

ALLERGY

SUFFERERS

When emptying any vacuum cleaner, it is difficult to avoid exposure to dust. To minimise this risk, please ensure that you encase the dust canister in a large bag to empty it. Close the bag as tightly as possible round the dust canister. Remove the dust canister and close the bag as tightly and quickly as possible and dispose of this immediately. It is advisable to wear disposable gloves and a face mask while emptying the cleaner. If at all possible, ask a non allergy sufferer to empty the dust canister when required.

FILTERS

Cleaning canister filter

1Access the filter assembly by removing the lid æ. Press the lid release button ô down then rotate the lid anti-clockwise E.

2Use the filter cleaning brush to remove any fluff from the outside of the mesh filter.

3Rotate mesh filter clockwise to disassemble the filters.

4Shake the pleated filter to remove any dust.

5Both the mesh and pleated filters may be washed (in cool water only) but must be thoroughly air dried before refitting.

IMPORTANT: Do not use detergents to clean the filters.

•A spare pleated filter is provided. This allows one to be in use whilst the other is washed and dried.

6To re-assemble, locate the pleated filter into the lid then secure into place with the mesh filter by rotating the mesh filter anti-clockwise.

7Fit the lid with filter assembly onto the canister then rotate clockwise until it locks into place.

6 For Advice, Spares or Accessories, tel: 0845 077 7700 (UK) or 1800 409 119 (Ireland)