Morphy Richards Boxer wet & dry vacuum cleaner manual Operation, Float shut-offwet use

•To fit the Foam filter

1 Remove cartridge filter.

2 Slide foam filter fully down over the float cage, located underneath the upper body. E

3 Inspect your filter regularly. To clean the filter, remove it from the float cage. If required rinse the filter in cold, water.

E

•To fit the Cartridge filter

1Position the filter and twist locking nut clockwise F

F

2To remove it turn the locking nut anti- clockwise.

3To clean it, brush the grooves with a soft brush, ensuring you don’t damage the surface.

4Inspect your filter regularly and if damaged replace it immediately.

5If used for wet pick-up wash the filter in cold water and thoroughly dry before re- fitting.

•To fit the Paper bag (if required)

1To fit the paper bag, place it inside the tank with the bag collar by the inlet. G

2Bend the top of bag collar back at the crease.

3Push the bag collar over the inlet so that the rubber seal holds the dust bag in place. G

G

Ô

Operation

1Unwind the lead fully and connect to the mains.

2Switch on using the on/off switch. ‹

Float shut-off wet use

When the tank is full of liquid the float shut-off valve H automatically cuts off the suction which is indicated by a higher pitched noise from the motor. If this occurs:

H

1Switch the unit OFF and disconnect from the mains.

2Raise hose to drain liquid back into the tank.

3Empty the tank.

IMPORTANT: Do not attempt to remove the float as this is important for safe performance. If the cleaner overturns during use, switch the motor off, return to the upright position and wait until the float falls free.

5