Morphy Richards Essentials Bag Vacuum Cleaner manual Turbo brush, Cleaning the turbo

73342 rev1 13/3/07 15:02 Page 5

C

Í

D

6Switch on/off.

•IMPORTANT: Always fix the hose clip È to the main body slot Ë when using the hose and tools.

•Never over extend the hose such that the cleaner is pulled over.

•Turning the cleaner sideways helps prevent the cleaner being pulled along by the stretch hose.

Turbo brush

(certain models only) Ú

This nozzle is suitable for cleaning and rejuvenating cut pile stair carpets and upholstery. It is ideal for picking up stubborn dirt and pet hairs.

Cleaning the turbo

nozzle (certain models only)

The turbo nozzle should be regularly cleaned and any hairs or fibres wrapped around the brush bar removed to maintain optimum performance.

DUST CANISTER

Dust bag indicator

When the cleaner is switched on, if the dust bag condition indicator is continuously showing red (or if the suction is reduced) the bag must be replaced and the filters cleaned.

If it is still showing red after emptying the dust bag and cleaning the filters, check to see if the hose is blocked.

carefully to avoid dust/dirt spilling from the dust bag and dispose.

4Take a new dust bag and fold over the top tab at the crease. Holding the cardboard tab, push the bag over the opening of the dirt discharge tube until it is seated against the rear of the enclosure.

5IMPORTANT: The front panel will not close unless the dust bag is correctly fitted due to the safety bag interlock. The interlock prevents the cover closing unless a bag is fitted.

6Once the new dust bag is in place, replace the front panel by aligning the bottom locking tabs with the slots in the body, close cover slowly allowing the front panel to snap in place. The latch will self lock.

Cleaning the pre- motor filter D

Everytime a new bag is fitted, the filter should be taken out and cleaned. Failure to clean the filter will reduce suction and will damage the motor if used for prolonged periods. This may invalidate the guarantee. If the filter becomes damaged it must be replaced.

IMPORTANT: Do not operate the cleaner without the filter in place.

1	Remove the front cover of the
	cleaner. The pre-motor filter is
	located below the bag.
2	To remove the filter, slide the
	holder out of the machine.
3	Remove the filter from the
	holder by unclipping. To clean

Changing the dust bag C

1Unplug the power cable from the socket.

2Remove the front by pressing the release lever at the top.

3Remove the old dustbag by holding the cardboard tab and pull towards you. Remove

shake vigorously over a dustbin.

•The pre-motor filter may also be washed in warm water.

•Do not use detergents. The filter must be completely dry before refitting. Allow the filter to dry naturally, do not overheat.

5Replace front cover.

5