Morphy Richards Hand held vacuum cleaner Assembling the product, Assembling Assembly, Nozzle

Hand held vac rev 3 73106/07 4/11/05 1:32 PM Page 5

Cleaning turbo nozzle (pets models only)

If the turbo nozzles rotating brush becomes entangled with hair it may require taking apart and cleaning

1Unclip the top half of the nozzle by pulling the upper casing out slightly and lifting off.E

E

Clear out any blockages /pet hair, remove all components.and clean if necessary.

2The main turbo wheel has a removable

collar, this must be re-assembled correctly, other wise the nozzle will not go back together.

3To re-assemble nozzle, take the brush bar with the toothed belt positioned over the track on the bar (notice the rectangular

F

locators on either side of the brush bar). F

Slot the brush bar into the relevent tracks on either side of the lower casing.

Ensuring that the turbo wheel is correctly placed, loop the toothed wheel through the belt and lower the turbo wheel into the grove, provided in the lower casing. The internal assembly should be complete.

4Ensuring that the brush bar, the turbo wheel and the belt are correctly located and positioned, take the top casing and position the slots over the teeth at the front of the lower casing and clip back into position.

G

After re-assembly fit turbo nozzle on unit and ensure the brush bar is rotating correctly.

Assembling the product

Assembling Assembly

Vacuum
‚	·	Ò
	Í
	·
	Î		Ì
	·	Í
			Ï
	Â
Blower	„
	‚
Ê
	·

Note Make sure the correct end is fixed to the blower adapter, (smooth end).

Nozzle

When using the brush nozzle Ò to get extra suction place your finger over the hole. This is only for vacuuming H

H

5